Document Type

Closed Project

Publication Date

Spring 1994

Instructor

Richard F. Deckro

Course Title

Total Quality Management II

Course Number

EMGT 510

Abstract

This team project studied the hub machining process at Consolidated Metco. The parts selected is part no. 102198. Thickness of the parts had very large variations resulting quite a few scrap. The control charts were set up to detect the problem with the process. Special causes were identified. The economic and practical suggestions were made to monitor and control the process. The team also Pointed out that although SPC has been implemented for several years, the processes are still out of control. The control charts should be set up correctly and then the charts should truly be used for on-line control.

Rights

In Copyright. URI: http://rightsstatements.org/vocab/InC/1.0/ This Item is protected by copyright and/or related rights. You are free to use this Item in any way that is permitted by the copyright and related rights legislation that applies to your use. For other uses you need to obtain permission from the rights-holder(s).

Comments

This project is only available to students, staff, and faculty of Portland State University.

Persistent Identifier

http://archives.pdx.edu/ds/psu/24174

Download

Share

COinS